Memory Board; Installing Extra Memory - Brother MFC-9125CN User Manual

Memory board

MFC-9325CW and MFC-9125CN have
64 MB of standard memory. They also have
one slot for optional memory expansion. You
can increase the memory up to a maximum of
576 MB by installing one SO-DIMM (Small
Outline Dual In-line Memory Module). When
you add the optional memory, it increases the
performance for both copier and printer
operations.
In general, the machine uses
industry-standard SO-DIMM with the
following specifications:
Type: 144 pin and 64 bit output
CAS latency: 2
Clock frequency: 100 MHz or more
Capacity: 64, 128, 256 or 512 MB
Height: 1.25 in. (31.75 mm)
Dram Type: SDRAM 2 Bank
For information regarding memory for your
Brother machine please visit us at:
www.brother-usa.com/support/memory.
Note
• There might be some SO-DIMMs that will
not work with the machine.
• For more information, call Brother
Customer Service.
126

Installing extra memory

B
a
Turn off the machine's power switch.
Unplug the telephone line cord.
b
Disconnect the interface cable from the
machine, and then unplug the power
cord from the AC power outlet.
Note
Be sure to turn off the machine's power
switch before you install or remove the
SO-DIMM.
c
Remove the plastic (1) and then
metal (2) SO-DIMM covers.
d
Unpack the SO-DIMM and hold it by its
edges.
IMPORTANT
To prevent damage to the machine from
static electricity, DO NOT touch the
memory chips or the board surface.
B
2
1