Brother MFC-255CW Network Manual page 50

Configuring your machine for a wireless network (Not available for DCP-365CN, DCP-395CN and MFC-295CN)
LCD messages when using the SES/WPS/AOSS control panel menu
LCD shows
Setting WLAN
Connecting SES
Connecting WPS
Connecting AOSS
Connected
Connection Error
No Access Point
Connection Fail
Note
• If you encounter a problem during setup, temporarily place your machine closer to the wireless access
point, and go back to step d.
• You can also manually configure the wireless settings following the steps starting at step a on page 28.
i
Press OK.
®
(Windows )
You have completed the wireless network setup. If you would like to continue installing drivers
and software necessary for operating your device, please choose Install MFL-Pro Suite or
Initial Installation / Install MFL-Pro Suite from the CD-ROM menu.
(Macintosh)
You have completed the wireless network setup. If you would like to continue installing drivers
and software necessary for operating your device, please choose Start Here OSX from the
CD-ROM menu.
Connection status
Searching or accessing the access point,
and downloading settings from the access
point.
Connecting to the access point.
Connection succeeded.
Session overlap has been detected.
The access point detection failed.
The machine was not able to connect with
the access point.
Action
—
—
—
Check that only one router or access
point has the SecureEasySetup™
mode, the Wi-Fi Protected Setup™
mode or AOSS™ mode enabled and try
starting from step d again.
Move the machine closer to your
access point/router and try starting from
step d again.
Try starting from step d again.
If the same message reappears,
reset the machine back to the
factory settings and try again.
3
41