Commonly Used At Commands - Motorola IDEN WIRELESS DATA SERVICES User Manual

Commonly Used AT Commands

The subset of AT commands supported by iDEN Wireless Data Services is
provided in this section for your reference.
These commands must be preceded by the command line prefix "AT", for
example, "ATa".
DCE refers to the modem on your iDEN phone.
DTE refers to your computer or hand-held device.
To enter commands, you can use upper- or lower-case letters, or both.
Answer
If an incoming (decoded) data service is pending, this
command instructs the DCE to immediately connect to the call
and start the answer sequence, as appropriate for the selected
service.
A
Action ATa
Query
Range
Command Mode Echo
The setting of this parameter determines whether or not the
DCE echoes characters received from the DTE during
command state and online command state.
Action ATe <echo>
E
Query AT&v
Range
Parameter Values:
0 Disable command mode character echo.
1 Enable command mode character echo.
N O T E
Appendix
83