Motorola IDEN WIRELESS DATA SERVICES User Manual page 76

Wireless Data Services
Establishing Communication
To set up your iDEN phone for packet data services using AT commands,
you must first establish basic communication with the modem function of
the phone.
If you have not connected the data cable to the computer and your phone, do
so now. If you need instructions, see "Connecting the Data Cable" on
page 11.
Software Connections
After you establish the hardware connections, you must run a terminal
software program on your computer. The terminal program provides simple
communication through the computer serial port.
To test the connection,
1. Type ATi4 in the Terminal Window.
2. Press Enter. You should see one of the following messages:
,
MOTOROLA IDEN
OK
If the Connection Fails
If the message, , or the message, 0, does not display when you issue the
OK
AT command, check the connections and try again. Make sure that:
The phone is powered on.
The cable is connected according to the instructions in
"Connecting the Data Cable" on page 11.
The serial (COM) port on the computer, to which the cable
is connected, is the same as the serial port specified in your
communication software.
The communication program that you are using is listed in
"
Configuring Communications Software
The software is configured according to the procedure
described in this section.
If, after taking the above measures, the connection continues to fail, see
"Troubleshooting" on page 60.
72
,
MOTOROLA
- or -
0
" .
page 58
IDEN