Cleaning And Maintenance - Fagor IP-200X Instructions For Use Manual

setting between the minimum and
maximum values ("Min" and "Max".
When you start up this functioning
mode, the hob will go to the pre-set
power setting, which is 4.
• TEMPERATURE MODE ("Temp")
(10): In this functioning mode, the
hob automatically adjusts the power
supply so that the temperature
remains constant. The temperatures
indicated for each setting (ºC) are
for guidance purposes only, and the
real temperature depends on the
pan type, food, etc. You will quickly
become familiar with its functioning
and can use it according to personal
tastes, using low temperatures to
keep stews hot, high temperatures for
deep-frying, etc.
Whenever you start up this
functioning mode, the hob will go
to the pre-set temperature setting,
180ºC.
• Select the desired power setting or
temperature by pressing the power
setting/temperature increase or decrease
buttons (6 and 7).
• Switch off the hob after use by pressing
the ON/OFF button. The fan will stop
running after 1 minute. Unplug the hob
and leave it to cool down.
6. LOCKING
When the appliance is connected, you
can activate the keypad lock by pressing
the lock selector (9). The corresponding
pilot light will come on. The hob can now
only be made to function by pressing the
ON/OFF button, and all the other buttons
will be disabled. To deactivate the lock
function, press the lock selector and hold it
down for 2 seconds (9).
7. TIMER
This induction hob includes a cooking time
programming option. The hob will switch
off automatically after the selected time has
elapsed. The procedure for programming a
cooking time is as follows:
• Press the timer button (5). You will hear
a beep and "0" will flash on the display.
• Press the "+" and "-" buttons to select
the desired functioning time. Each time
you press one of these buttons the time
will increase or decrease by 1 minute. If
you hold one of the buttons down, the
time will increase or decrease by blocks
of 10 minutes.
• After selecting the desired cooking time,
wait for 5 seconds. The display will stop
flashing and the time will be stored in
the memory. If the timer is set to 0 this
will have no effect.
• If you have programmed the cooking
time and wish to cancel the setting,
simply press the timer button (5) again.
NOTE: Even if you have not used the timer
function, the hob will always automatically
switch off after a maximum functioning
time. This varies depending on the power
setting or temperature selected, as shown
in the table below.
Power setting
Automatic switch-off 4 4
(hours)

8. CLEANING AND MAINTENANCE

1. Unplug the appliance and allow the hob
to cool down.
2. Use a soft dry cloth to gently remove
any dust that has accumulated in the air
vent and air inlet.
3. If the hob is not excessively dirty, clean
it with a damp cloth.
4. If there are grease stains on the hob,
clean it with a damp cloth and a little
toothpaste or neutral detergent.
5. Never use abrasive or degreasing
cleaning agents or alcohol.
11
1 2 3 4 5 6
3 3 2 2