Cleaning And Maintenance - Fagor IO-HOB-0994 Instruction Manual

CLEANING AND MAINTENANCE

Proper routine maintenance and cleaning
of the appliance can significantly extend its
trouble-free operation.
B e f o r e c l e a n i n g o r o t h e r
maintenance work, always unplug
the appliance or use the main
electrical system circuit breaker
to cut off power. Do not begin
cleaning until the hob has cooled.
Do not use abrasive scouring
powders.
Do not use steam cleaning
equipment for cleaning.
Burners, hob grid
If the burners and grid become soiled,
remove them from the hob and wash in
warm water with some dishwashing liquid.
Wipe dry. Once the grid is removed, thor-
oughly clean the area under the burner
and wipe it dry with a soft cloth. Flame
outlets and burner head must be clean at
all times, see figure below. Clean the gas
nozzles using a thin copper wire. Do not
use steel wire or ream the holes.
All burner parts must be always
dry. Water droplets may block the
gas flow and cause the burner to
operate incorrectly.
Make sure that burner is correctly re-
assembled after cleaning.
CORRECT
INCORRECT
• Use mild detergents to wash enamel
surfaces. When cleaning do not use abra-
sive cleaners such as scouring powders,
pastes, abrasive stones, pumice, metal
scrubbers, etc.
• Thoroughly clean the stainless steel
hob before use. Especially make sure
to remove any adhesive residue or self-
adhesive tape applied when the appli-
ance was packaged.
• Clean the hob after each use. Do not
allow the hob to get heavily stained;
particularly from burnt–on spillages from
boiled over liquids.
Regular inspections
In addition to normal cleaning and mainte-
nance:
● carry out periodic checks of touch controls
and other elements. After the warranty
expires, have authorised service inspect
the appliance every two years,
● repair any operational faults,
● carry out periodic maintenance of the hob,
45