Characteristics Of Network Functions When Connecting With The Web - Acer HDS AMS200 Reference Manual

When collecting memory dump (Full Dump) using Netscape Navigator
attention to free space on the PC because information to be downloaded will not be
compressed.
8.2.2

Characteristics of Network Functions When Connecting with the Web

This section discusses the following network function characteristics when connecting with
the Web:
LAN Interface
The connector for 10Base-T/100Base-TX is equipped with the controller. 10Base-
T/100Base-TX is selected automatically.
Network Parameter
The AMS200 has the following network parameters; they can be set or changed by the
Web browser or the Storage Navigator-Modular, concerning only port 1 (for user
management) of each controller.
Table 8.3 Network Parameters
Network Parameter
IP Address
Subnet Mask
Default Gateway
DHCP
(see Note 2)
Note 1: Manage the IP Address after the IP Address is changed from the IP Address of factory
setting.
Note 2: When the DHCP mode is validated, the IP Address is acquired from the DHCP server.
If the DHCP server is not started up, or if the DHCP function has been wrongly set, the
acquisition of the IP Address will fail, and the IP Address of the subsystem will remain
0.0.0.0. (This is a state in which Disk Array management program 2 or the Web cannot be
used via a LAN.)
Note 3: In this case, you can acquire the IP Address by starting up the DHCP server or by
setting the DHCP function correctly, when necessary.
Description
The IP Address is
changed/set up.
The Subnet Mask is
changed/set up.
The Default Gateway is
changed/set up.
Enable/Disable of the DHCP
function is set up.
Acer | HDS AMS200 User and Reference Guide
Factory Setting Value (see Note 1)
Controller 0
For User-managed Port
192.168.0.16
(see Note 1)
255.255.255.0
(see Note 3)
0.0.0.0
Off
®
4.7x, pay
Controller 1
For User-managed Port
192.168.0.17
(see Note 1)
255.255.255.0
(see Note 3)
0.0.0.0
Off
217