Setting A Raid Group; Figure 7.2 Logical Status Tab - Acer HDS AMS200 Reference Manual

7.4.3

Setting a RAID Group

Note: It is recommended that you set at least four RAID Groups for the RAID group used
when the NAS unit is connected. This sets the NAS system LU for the usual operation, the
NAS system LU for backup, and the NAS user LU into another RAID Group.
To set a RAID group, follow these steps:
1. Turn on the power supply.
Note: If the power supply has been turned on, proceed to the next step.
2. Start the Storage Navigator-Modular program, and set the operation mode to
Management Mode.
3. Click the icon of an array unit on the Main window, select the Settings menu, and then
click Display Details. Alternately, click Display Details on the tool bar.
4. Click the Logical Status tab.
5. From the Settings menu, select RAID Group, and then click Settings. Alternatively, click
RAID Group Settings in the tool bar.
This operation can also be completed from the context menu of the RAID Groups box.
6. On the RAID Group dialog, select or enter the RAID Level, Drive Configuration(Drive
Type, Drive Capacity, Combination, and Parity Groups), and then click OK. For the
Drives, select Automatic Selection.
7. A confirmation message displays. Click OK.
8. If the RAID group setting is not successful, delete the affected RAID group, and try
creating the RAID group again.
Figure 7.2
138 Chapter 7 Configuring Storage on the Thunder 9530™ V Series Subsystem
Logical Status Tab