84
7
Insert the module into the fibre channel module connector. Make
sure that the card is properly seated (C).
8
Rotate the retention latch downward.
9
Connect any required cable to the module.
10 Observe the post-installation instructions described on page 38.
ARMC/3 or BMC module
The ARMC/3 (optional) or BMC module provides server management
firmware and functionality for the system.
Removing the ARMC/3 or BMC module
1
Observe the ESD precautions and pre-installation instructions
described on page 37.
2
Remove the memory boards or memory air baffles from DIMM
slots C and D. See "Cold Removal of Memory Board" on page 75
and "Removing a memory board air baffle" on page 46.
3
Hold the module both by the loop finger grip and by the opposite
corner (A).
Caution: Do not bend or twist the module.
3 System upgrade