Installing Dimms - Acer Altos R910 Series User Manual

Installing DIMMs

Caution! Use extreme care when installing a DIMM. Applying too
much pressure can damage the connector. DIMMs are keyed and
can be inserted in only one way.
Note: DIMM slots on the memory module must be installed only
in certain configurations. Numbers next to DIMM slots correspond
to installation sequence. DIMMs must be installed in pairs.
1 Observe the ESD precautions and pre-installation instructions
described on page 37.
2 Remove the memory board. For instructions, see "Hot-removal of a
memory board" on page 57 or "Cold-removal of a memory board"
on page 75, depending on your server configuration.
3 Remove the memory board DIMM cover from the memory board:
(1) Pull out the latch on the memory board DIMM cover (A).
(2) Press the left and right DIMM cover tabs (B).
(3) Press the retainer tab, on the lower right of the cover (C).
(4) Lift the cover from the memory board (D).
4 Locate the DIMM slots on the memory board.
5 Open the clips on the DIMM slot(s) (A).
6 Align (B) then insert the DIMM into the socket (C).
79