Pci Card - Acer Altos R910 Series User Manual

Removing DIMMs
Before you can install a new DIMM in a socket, remove first any
previously installed DIMM from that socket.
Important: Before removing any DIMM from the mainboard,
make sure to create a backup file of all important data.
Caution! Use extreme care when removing DIMMs. Too much
pressure can damage the connector. Apply only enough pressure
on the plastic levers to release the DIMM.
1 Perform steps 1 to 5 described in the "Installing DIMMs" section.
2 Gently pull the DIMM upward to remove it from the socket.
3 Install the memory board. For instructions, see "Hot-insertion of a
Memory Board" on page 58 or "Cold Insertion of a Memory
Board"on page 76, depending on your server configuration.
4 Observe the post-installation instructions described on page 38.
To reconfigure the system memory:
The system automatically detects the amount of memory installed. Run
the BIOS setup to view the new value for total system memory and
make a note of it.

PCI card

PCI cards installed in slots 1 to 5 are hot-pluggable. If you are adding or
removing a card from one of these slots, you can do so without
powering down the server.
Removing a non-hot-plug PCI card
Caution! Damage to the system occurs if power is not removed
from the system prior to removal or installation of non-hot-plug
boards.
81