C
2: H
HAPTER
22
Powering Up the
Router
I
ARDWARE
NSTALLATION
You should leave the Authentication Method as its default: Auto if your
ISP doesn't specify this parameter.
If your ISP allocates fixed or static IP information, you need the following
information:
IP Address
Subnet Mask
Default Router address : ____.____.____.____
DNS address
If your ISP allocates IP information dynamically over a protocol other
than PPPoE, you do not need any further information. This configuration
is typical of cable connections.
To power up the Router:
1 Plug the power adapter into the power adapter socket located on the
back panel of the Router.
2 Plug the power adapter into a standard electrical wall socket.
: ____.____.____.____
: ____.____.____.____
: ____.____.____.____