Powering On The Router; Startup Process - 3Com Router 3016 Installation Manual

Powering on the
Router
Checking and operating
after power-on

Startup Process

Before you power on the router, verify that:
The connection between the power cord and ground wire is secure
■
The voltage of the power supply complies with the requirement of the router
■
The console cable is correctly connected to either the PC or the terminal, and
■
that the settings are correct
Warning: Before switching on the power, locate the power-off switch in the
workroom so that, in case of an electrical accident, power can be turned off
quickly.
Turn on the power switch of the router.
After the router is powered on, verify that:
The LEDs on the front panel are normal.
■
For the status of the LEDs during normal operation after power-on, see the LED
tables in Chapter 1.
The console terminal display is normal
■
For the local configuration, the startup interface on the console terminal
displays after the router is powered on. See Startup Process.
For the remote configuration, you must dial up, using HyperTerminal, after the
router is powered on, as shown in Figure 7. After the dial up, the startup
interface is displayed on the terminal. See Startup Process.
Figure 7 Connect Dialog Box
After the POST, press Enter. When the [3Com] prompt displays, you can configure
the router.
After the router starts up, the Boot ROM program runs and the following
information displays on the terminal screen:
Booting
********************************************

Powering on the Router

39