Table of Contents
Advertisement
LAN Settings
Unit Configuration
Figure 29 LAN Setup Screen
This screen allows you to change the IP address and subnet mask.
1 IP Address: Enter the IP Address for your LAN interface.
2 Subnet Mask: Enter the Subnet Mask for your LAN interface.
3 Enable IGMP Snooping: The Internet Group Management Protocol
snooping can snoop on IGMP query, report and leave packets
transferred between IP Multicast Routers/Switches to learn the IP
Multicast group membership. It checks IGMP packets passing through
it, picks out the group registration information, and configures
multicasting accordingly. Select on the box to enable it.
4 Enable DHCP server on the LAN: Check this box to enable the DHCP
service on the router.
The Firewall Router contains a Dynamic Host Configuration (DHCP)
server that can automatically configure the TCP/IP settings of every
computer on your network.
5 Select Enable the DHCP server with the following settings: Enter the
start and end IP Address of your DHCP range. Enter the leased time in
hours to specify the frequency for DHCP assignment.
6 Configure the second IP Address and Subnet Mask for the LAN
interface: Check this box to make another set of IP Address and
LAN Settings
49
Advertisement
Table of Contents
