Check After Power-On (Recommended); Startup Process - 3Com S7906E Getting Started Manual

Power on the switch.

Check after Power-On (Recommended)

You are recommended to check as follows after powering on the switch to ensure the configurations
thereafter.
After a switch is powered on, the heat dissipation system starts working. You can hear the noise as
the fan rotates and feel air flow out from the vent.
Check if any system indicator on the SRPU indicates abnormal condition.

Startup Process

As the switch is started, the configuration terminal will yield the following output:
The following information may slightly vary with switch models and software versions.
Starting......
RAMLine.....OK
System is booting...........***.....
******************************************
*
* 3Com S7900E BOOTROM, Version 206
*
******************************************
Copyright(c) 2004-2008 3Com.
Creation date
CPU type
CPU Clock Speed : 600Mhz
BUS Clock Speed : 66Mhz
BOOT_FLASH type : M29W040B
Flash Size
Memory Size
Main board slot 0 self testing............................
SDRAM Data lines selftest.................................OK!
SDRAM Address lines selftest..............................OK!
SDRAM fast selftest.......................................OK!
CPLD selftest.............................................OK!
FPGA selftest.............................................OK!
: Apr 11 2008, 10:15:28
: BCM1125H
: 64MB
: 512MB
4-5
*
*
*