3Com S7906E Getting Started Manual page 129

9) Click Send. The system displays the following interface.
Figure 6-4 File sending interface
After the downloading is completed, the system displays the following information:
Loading ...CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC.done!
Free flash Space : 65932288 bytes
Writing flash.....................................................................
..........................................................................
..........................................................................
..........................................................................
..........................................................................
..........................................................................
.....................................................................done!
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):
After the above steps, you have completed the downloading of the host software package.
To complete the host software upgrade, you need to set the main/backup attribute of the host software.
For details, refer to "Setting the Main and Backup Host Software Through the Boot Menu" on page 6-11.
If you need to upgrade the Boot ROM on the SRPUs through the boot menu, refer to section "Updating
Boot ROM Through a File on the Flash" on page 6-12.
6-10