3Com S7906E Getting Started Manual page 33

software loading, or to a modem for remote system debugging, configuration, maintenance and
management.
Table 1-37 Specifications of the console port
Item
Connector type
Number of connectors
Interface standard
Baud rate
Transmission distance
Functions
10/100Base-TX management Ethernet port
Using an RJ-45 connector, the 10/100Base-TX management Ethernet port can be connected to a local
PC for switch program loading and switch debugging, or connected to a remote NMS for remote
management.
Table 1-38 Specifications of the 10/100Base-TX Ethernet port for management
Item
Connector type
Number of interfaces
Interface speed
Cable medium and maximum
transmission distance
Function
Table 1-39 Description of the status LEDs of the 10/100Base-TX management Ethernet port
LED
LINK
ACT
System LEDs
System status LEDs
The LEDs on the card panel indicate the statuses of the power modules, fan tray, twelve LPUs, and
LSQ1SRP2XB0 itself.
Power status LEDs
PWR: The power status LEDs show the status of the power modules.
RJ-45
1
Asynchronous EIA/TIA-232
115,200 bps (defaulting to 9,600 bps)
15 m (49.21 ft.)
It can be connected to an ASCII terminal.
It can be connected to a serial port of a local or remote
(through a pair of modems) PC running terminal
emulation program.
RJ-45
1
10/100 Mbps, half/full duplex
Category-5 twisted pair, with a maximum transmission
distance of 100 m (328.08 ft.)
Used for switch software upgrade and network management
OFF: No link is present.
ON: A link is present.
OFF: No data is being transmitted or received.
Blinking: Data is being transmitted or received.
1-27
Specifications
Specifications
Description