D-Link DES-3326 User Manual page 163

DES-3326 Layer 3 Fast Ethernet Switch User's Guide
BOOTP/DHCP Relay
To enter the IP addresses of BOOTP or DHCP servers (for the BOOTP/DHCP Relay service):
Highlight Utilities on the Main Menu and press Enter. Next, highlight BOOTP/DHCP Relay on the
Switch Utilities menu and press Enter.
The following fields can be set:
Figure 6-85. BOOTP/DHCP Relay menu
Parameter
BOOTP/DHCP
Relay Status
<Disabled>
BOOTP HOPS
Count Limit [4 ]
BOOTP/DHCP
Relay Time
Threshold:[0 ]
Description
This field can be toggled between
Enabled and Disabled using the
space bar. It is used to enable or
disable the BOOTP/DHCP
service on the switch. The default is
Disabled.
This field allows an entry between 1
and 16 to define the maximum
number of router
messages can be forwarded across.
The default hop count is 4.
Allows an entry between 0 and
65535 seconds, and defines the
maximum time limit for routing a
BOOTP/DHCP packet. If a value of 0
is entered, the switch
process the value in the seconds field
of the BOOTP or DHCP packet. If a
non-zero value is entered, the switch
will use that value, along with the
hop count to determine whether to
forward a given BOOTP or DHCP
packet.
163
Relay
hops BOOTP
will not