D-Link DES-3326 User Manual page 141

DES-3326 Layer 3 Fast Ethernet Switch User's Guide
The following fields can be set:
Interface Name:
[ ]
NBR Report
Timer:[35
Route Cost:[1 ]
State:<Disabled>
IP Address:
Probe Interval:
[10 ]
PIM-DM
To configure PIMDM for an IP interface:
Highlight PIMDM Interface Configuration from the Setup IP Multicast menu and press Enter.
Parameter
Allows the entry of the name of the IP interface for which
DVMRP is to be configured. This must be a previously
defined IP interface.
This field allows an entry between 1 and 65,535 seconds
] and defines the time period for DVMRP will hold Neighbor
Router reports before issuing poison route messages. The
default is 35 seconds.
This field allows an entry between 1 and 255 and defines
the route cost for the IP interface. The DVMRP route cost is
a relative number that represents the real cost of using this
route in the construction of a multicast delivery tree. It is
similar to, but not defined as, the hop count in RIP. The
default cost is 1.
This field can be toggled between Enabled and Disabled and
enables or disables DVMRP for the IP interface. The default
is Disabled.
Displays the IP address corresponding to the IP Interface
name entered above.
The Probe Interval field allows an entry between 1 and
65,535 seconds and defines the interval between 'probes'.
The default is 10.
Figure 6-59. PIM-DM Interface Configuration screen
Description
141