Igmp Snooping - D-Link DES-3226 User Manual

The Spanning Tree Protocol will treat a port trunking group as a single link, on the switch level. On the
port level, the STP will use the port parameters of the Master Port in the calculation of port cost and in
determining the state of the port trunking group. If two redundant port trunking groups are configured
on the Switch, STP will block one entire group – in the same way STP will block a single port that has a
redundant link.
The Link Aggregate Control Protocol (LACP) allows you to bundle several physical ports together to form
one logical port. In contrast to traditional port trunking as explained above, LACP trunking requires
every member port to use the same protocol. If, for example, one member port on a switch does not
support LACP, then that port cannot be a member of the port trunking group.
The user-changeable parameters in the Switch are as follows:
•
Group ID [1] – This field is for a group ID number for the port trunking group.
•
Group Name [
•
Type [TRUNK] – If LACP is selected, each member of the port trunking group must support the Link
Aggregate Control Protocol. There is no protocol requirement if TRUNK is selected.
•
State [Disabled] – This field can be toggled between Enabled and Disabled. This is used to turn a
port trunking group on or off. This is useful for diagnostics, to quickly isolate a bandwidth intensive
network device or to have an absolute backup aggregation group that is not under automatic
control.
•
Member ports – Check each port of the port trunking group.

IGMP Snooping

Internet Group Management Protocol (IGMP) snooping allows the Switch to recognize IGMP queries and
reports sent between network stations or devices and an IGMP host. When enabled for IGMP snooping,
the Switch can open or close a port to a specific device based on IGMP messages passing through the
Switch.
To set up IGMP snooping, enter a VLAN ID number in the first field and change the State field to
Enabled. Next, select the desired setting in the Querier State field—this determines the version of
IGMP that is used in your network—and enter values in the following three fields. A value between 1
and 255 can be entered for the Robustness Variable (default is 2). The Query Interval can be set
between 1 and 65535 seconds. This sets the time between IGMP queries. The Max Response allows a
setting between 1 and 25 seconds and specifies the maximum amount of time allowed before sending a
response report. Click Apply to make the settings effective.
] – Enter a name for the port trunking group.
Figure 7-7. IGMP Snooping Settings window
DES-3226 NWay Standalone Fast Ethernet Switch User's Guide
98