Configure Ports - D-Link DES-3226 User Manual

DES-3226 NWay Standalone Fast Ethernet Switch User's Guide
•
Trunk Load Sharing Algorithm:<Src Address> – The trunk load sharing options are Dst Address,
Src&Dst Address, and Src Address.
•
Backpressure:<Disabled> – This allows you to enable or disable the backpressure function for the
Switch.
•
Switch GMRP:<Disabled> – Group Multicast Registration Protocol is a protocol that allows
members to dynamically join Multicast groups. GMRP must also be enabled on specific ports on the
Port GMRP Settings screen for it to take effect. This global control is especially useful if you want
to turn off GMRP on the whole Switch without making changes to each individual port.
•
Switch 802.1X:<Disabled> – Set the 802.1X access control by toggling between Enabled and
Disabled.
•
Switch Filtering EAPOL PDU:<Yes> – This option is only available if 802.1X is disabled. It filters
Extensible Authentication Protocol Over LANs Packet Data Units (EAPOL PDU) when enabled.
•
Switch Traffic Segmentation:<Disabled> – When this feature is Enabled, ports on the Switch are
not able to communicate with one another. If there is not an optional module present, Port 1
becomes the server port. If there is a 1-port optional module, this port will be the server port. If
there is a 2-port optional module, both ports act as server ports.

Configure Ports

Highlight Configure Ports from the Configuration menu and press Enter:
Toggle the View Ports field, using the space bar, to view the configuration of either ports 1 through 12
or ports 13 through 24. To configure a specific port, toggle the Configure Port from [ ] to [ ] field until
the appropriate port number or port range appears.
Toggle the State field to either enable or disable a given port.
Toggle the Speed/Duplex field to select the speed and duplex/half-duplex state of the port. Auto means
auto-negotiation between 10 and 100 Mbps devices, in full- or half-duplex mode. The Auto setting
allows the port to automatically determine the fastest settings the device the port is connected to can
handle, and then to use those settings. The other options are 100M/Full, 100M/Half, 10M/Full, and
10M/Half. There is no automatic adjustment of port settings with any option other than Auto.
Figure 6-14. Configure Ports screen
49