Postscript Header; Postscript Error Info; Postscript Timeout Values; Advanced - HP LaserJet 2605, 2605dn, 2605dtn Reference

The Archive format creates a PostScript data stream that gets stored in a file that you can use later.
This does not take advantage of any printer device features.
If you have an HP printer that supports both PostScript and another printer language, you may need to
click PJL archive format. This notifies the printer that the document is being printed in a different printer
language.

PostScript header

Specifies whether to send header information to the printer each time you print a document.
If you print to a local printer, you can save printing time by sending the header information to your printer
only once. However, sending header information each time you print a document is sufficient for most
types of printing, and is especially recommended if you print to a shared network printer or to a file on
a disk.
This setting is ignored for EPS and Archive formats.

PostScript error info

Specifies whether to print PostScript error messages after your document has been printed. The
PostScript print driver can detect certain errors that Windows cannot. If you are having printing problems,
click this option. This information may help you, a system administrator, or a printer-support
representative determine what caused the problem.
The error message information is not included in EPS format.

PostScript timeout values

Use the following options to specify the postscript timeout values for the printer.
●
Job timeout. This control specifies how long the document can take to get from the computer to
the printer before the printer stops trying to print the document. If you specify 0 seconds, the printer
continues trying to print indefinitely. The default setting is 0 seconds. You can use the spin box to
change this value to a maximum of 999 seconds.
●
Wait timeout. This control specifies how long the printer waits to get more postscript information
from the computer. After the specified time passes, the printer stops trying to print the document
and prints an error message. If you are trying to print a very complicated document, you might want
to increase this value. If you specify 0 seconds, the printer waits indefinitely. The default setting
is 240 seconds. You can use the spin box to change this value to a maximum of 999 seconds.

Advanced

Click the Advanced button for advanced PostScript options:
240 Chapter 6 Windows HP Traditional PCL 6 Driver features ENWW