Setting The Stereo Out And Bus Out 1-8 From The Display - Yamaha DM1000 Owner's Manual

Setting the Stereo Out and Bus Out 1–8 from the Display
To set the Stereo Out and Bus Out 1–8 parameters, you can either move the cursor to the
desired parameter on the display and change the value, or operate the desired button or
control on the top panel.
This section explains how to set the parameters on the display.
Tip: Refer to Chapter 9 "Input & Output Patching" on page 105 for more information on
how to set inserts.
Attenuating the Stereo Out and Bus Out
To attenuate the Stereo Out and Bus Out signals, press the SELECTED CHANNEL EQUAL-
IZER [DISPLAY] button repeatedly to display the EQ | Out Att page. On this page, you can
attenuate the Bus Out 1–8, Aux Out 1–8, and Stereo Out signals.
The parameters on this page (and the procedure for setting them) are the same as for Input
Channels, except that this page does not include the bit shift parameters (see page 64).
Delaying the Stereo Out and Bus Outs
To delay the Stereo Out and Bus Out 1–8 signals, press the [
repeatedly until the
The parameters on this page (and the procedure for setting them) are the same as for Input
Channels, except that this page does not include the MIX/FB.GAIN parameters (see
page 61).
Tip: You can also display the Out Dly page by pressing the [
then press the [SEL] button or move the fader to select the Stereo Out or Bus Out 1–8.
Setting the Stereo Out and Bus Out 1–8 from the Display
/INS/DLY | Out Dly page appears.
81
/INSERT/DELAY] button
/INSERT/DELAY] button once,
DM1000—Owner's Manual
7