Yamaha DM1000 Owner's Manual page 308

308
Appendix A: Parameter Lists
DIST->DELAY
One input, two output distortion and delay effects in series.
Parameter
DST TYPE
DRIVE
MASTER
TONE
N. GATE
DELAY
FB. GAIN
HI. RATIO
FREQ.
DEPTH
DLY.BAL
SYNC
DLY.NOTE
MOD.NOTE
1.
tempo setting)
2.
MULTI FILTER
Two input, two output 3-band multi-filter (24 dB/octave).
Parameter
TYPE 1
TYPE 2
TYPE 3
FREQ. 1
FREQ. 2
FREQ. 3
LEVEL 1
LEVEL 2
LEVEL 3
RESO. 1
RESO. 2
RESO. 3
DM1000—Owner's Manual
Range
DST1, DST2, OVD1,
Distortion type (DST = distortion, OVD = overdrive)
OVD2, CRUNCH
0–100 Distortion drive
0–100 Master volume
–10 to +10 Tone control
0–20 Noise reduction
0.0–2725.0 ms Delay time
Feedback gain (plus values for normal-phase feedback,
–99 to +99%
minus values for reverse-phase feedback)
0.1–1.0 High-frequency feedback ratio
0.05–40.00 Hz Modulation speed
0–100% Modulation depth
Distortion and delay balance (0% = all distortion, 100% = all
0–100%
delayed distortion)
OFF, ON Tempo parameter sync on/off
1
Used in conjunction with TEMPO to determine DELAY
2
Used in conjunction with TEMPO to determine FREQ.
Range
HPF, LPF, BPF Filter 1 type: high pass, low pass, band pass
HPF, LPF, BPF Filter 2 type: high pass, low pass, band pass
HPF, LPF, BPF Filter 3 type: high pass, low pass, band pass
28.0 Hz–16.0 kHz Filter 1 frequency
28.0 Hz–16.0 kHz Filter 2 frequency
28.0 Hz–16.0 kHz Filter 3 frequency
0–100 Filter 1 level
0–100 Filter 2 level
0–100 Filter 3 level
0–20 Filter 1 resonance
0–20 Filter 2 resonance
0–20 Filter 3 resonance
Description
(Maximum value depends on the
Description