Using The Control Room Monitor; Using The Solo Function - Yamaha DM1000 Owner's Manual

118
Chapter 10—Control Room Monitoring

Using the Control Room Monitor

1 Connect a monitoring system to the outputs (by default, OMNI OUT 11&12)
to which the Control Room Monitor signal is patched.
To monitor the signal via headphones, connect headphones to the PHONES jack.
2 Press the MONITOR [STEREO], [2TR D1], or [2TR D2] button to select the
monitoring signal source.
Each button selects the following monitoring signal sources:
• [STEREO] button ........ Selects the Stereo Out signal.
• [2TR D1] button .......... Selects the 2TR IN DIGITAL1 signal.
• [2TR D2] button .......... Selects the 2TR IN DIGITAL2 signal.
Note: In this case, the [2TR D1] and [2TR D2] buttons are effective only when external devices
are connected to the 2TR Digital Outputs respectively and are turned on.
Tip: If you change the 2TR DIN FLIP parameter setting on the MONITOR | SOLO/C-R page
(see page 116), you can monitor the 2TR Digital Input signal, instead of the OMNI IN signal,
by pressing the [2TR D1] or [2TR D2] button.
3 Adjust the monitoring level using the MONITOR [MONITOR LEVEL] control
while playing the sound sources.
To adjust the level of the monitoring signal via headphones, turn the [PHONE LEVEL] con-
trol.

Using the Solo Function

You can solo and monitor Input Channels, Aux Out 1–8, and Bus Out 1–8 using the
[SOLO] buttons on the top panel.
1 Press the [DISPLAY] button repeatedly until the Monitor | Solo/C-R page
appears.
2 Set the SOLO parameter to On and the SOLO INTERRUPTION parameter to
Off.
Set other parameters on the page, if necessary.
3 To solo and monitor Input Channels, press the corresponding LAYER button
to select a Layer that contains the desired channels, then press the channel
[SOLO] buttons.
The channel [SOLO] button indicators and the MONITOR [SOLO] indicator light up.
Only the soloed Input Channel signals are fed to the Control Room Monitor outputs.
Tip: If the SEL MODE parameter is set to Mix Solo on the Monitor | Solo/C-R page, you can
solo multiple Input Channels simultaneously.
4 To solo and monitor Output Channels, press the LAYER [MASTER] button,
then press the channel [SOLO] buttons.
Input and Output Channels (Aux Out 1–8, Bus Out 1–8) cannot be solo-monitored simul-
taneously. For example, if you solo an Input Channel, then solo an Output Channel, the
first solo channel is temporarily cancelled.
If you solo an Output Channel first, then solo an Input Channel, canceling the Input Chan-
nel's solo will activate the Output Channel's solo.
5 You can unsolo all soloed channels by pressing all illuminated channel
[SOLO] buttons.
The button indicators turn off. You can also unsolo all soloed channels by pressing the
MONITOR [CLEAR] button.
DM1000—Owner's Manual