Setting Send Levels; Flip Mode - Yamaha DM1000 Owner's Manual

218
Chapter 17—Remote Control

Setting Send Levels

You can adjust Pro Tools Send (A–E) send levels as follows.
1 Press the AUX SELECT [AUX 1]–[AUX 5] buttons to select the desired Sends
(A–E).
2 Rotate the Encoders for the desired channels.
You can set Send levels by rotating the Encoders if faders, Encoders, and [ON] buttons are
in Flip mode. Refer to "Flip Mode" for more information.
Muting Sends A–E
You can mute Sends by pressing the [ON] buttons if faders, Encoders, and [ON] buttons
are in Flip mode. Refer to "Flip Mode" for more information.
Panning Sends A–E
You can pan only Sends assigned to stereo destinations by rotating the Encoders if faders,
Encoders, and [ON] buttons are in Flip mode. Refer to the next section for more informa-
tion.

Flip Mode

In Flip mode, you can use the faders, Encoders, and [ON] buttons to control send levels,
pre/post positions, and mute settings as shown in the following table.
Faders
Encoders
Encoder push-switches
[ON] buttons
1 Press the FADER MODE [FADER/AUX] button.
The FADER MODE [FADER] and [AUX] indicators flash alternately, and the SELECT
ASSIGN parameter on the display indicates "FLIP."
2 Press the AUX SELECT [AUX 1]–[AUX 5] buttons to select the desired Sends
(A–E).
The button indicator of the selected send lights up.
3 Use the faders, Encoders, and [ON] buttons to control the currently-selected
send.
For stereo Aux input channels, you can set the left and right panpots individually. To do this,
press the ENCODER MODE [PAN] button repeatedly. When the button indicator is lit
continuously, you can set the left panpot. When the button indicator is flashing, you can set
the right panpot.
DM1000—Owner's Manual
Control
Channel level
Channel pan/send level
Encoder mode is Pan: inactive;
Encoder mode is Send level: Send pre/post
Channel mute
Normal mode Flip Mode
Send level
Send pan
Send pre/post
Send mute