Maintenance And Cleaning; Canceling The Programme; Cleaning The Detergent Drawer; Standby Mode - Beko WMB 51021 CS PT Manual

Canceling the programme

To cancel the programme, turn the Programme
Selection knob to select another programme.
Previous programme will be canceled. End /
Cancel light will flash continuously to notify that
the programme has been canceled.
Your machine will end the programme when you
turn the Programme Selection knob; however,
it does not drain the water inside. When you
select and start a new programme, the newly
selected programme will start depending on the
step the previous programme was canceled in.
For example, it may take in additional water or
continue to wash with the water inside.
Depending on the step where the
C
programme was canceled in, you may have
to put detergent and softener again for the
programme you have selected anew.

Standby mode

When the machine does not make any washing
for approximately 4 minutes, it switches to
Standby mode to save energy. Unnecessary
indicator lights and indicators will turn off in this
mode. Thus, maximum energy saving is ensured.
To exit the Standby mode, turn the Programme
Selection knob or just press any button.

5 Maintenance and cleaning

Service life of the product extends and frequently
faced problems decrease if cleaned at regular
intervals.

Cleaning the detergent drawer

Clean the detergent drawer at regular intervals as
shown below in order to prevent accumulation of
powder detergent in time.
Press the dotted point on the siphon in the
softener compartment and pull towards you until
the compartment is removed from the machine.
If more than normal amount of water and
C
softener mixture starts to gather in the
softener compartment, the siphon must be
cleaned.
Wash the detergent drawer and the siphon with
plenty of lukewarm water in a washbasin. Wear
protective gloves or use an appropriate brush to
avoid touching of the residues in the drawer with
your skin when cleaning. Insert the drawer back
into its place after cleaning and make sure that it
is seated well.

Cleaning the water intake filters

There is a filter at the end of each water intake
valve at the rear of the machine and also at
the end of each water intake hose where they
are connected to the tap. These filters prevent
foreign substances and dirt in the water to enter
the washing machine. Filters should be cleaned
as they do get dirty.
Close the taps. Remove the nuts of the water
intake hoses to access the filters on the water
intake valves. Clean them with an appropriate
brush. If the filters are too dirty, take them out
by means of pliers and clean them. Take out the
filters on the flat ends of the water intake hoses
together with the gaskets and clean thoroughly
under running water. Replace the gaskets and
filters carefully in their places and tighten the hose
nuts by hand.
Draining remaining water and
cleaning the pump filter
The filter system in your machine prevents solid
items such as buttons, coins and fabric fibers
clogging the pump impeller during discharge of
13
EN