Denon AVR-4306 Operating Instructions Manual page 58

Advanced Operation
MODE SELECTOR
Preset memory
The included remote control unit (RC-1024) can be used to
operate devices of different brands by registering the preset
number corresponding to the brand of your device.
For some models the remote control unit or the device may not
operate properly. In this case, use the learning function (
page 56) to store your device's remote control signals in the
included remote control unit.
1
MODE SELECTOR
Press the
component you want to preset.
Presetting is not possible for the AMP, ZONE2, ZONE3,
TUNER and SYSTEM CALL modes.
2
SETUP
Press and hold the
three seconds.
• The top IR segment blinks twice.
3 Referring to the included List of Preset Codes
IR segment
(
button to input the preset code (a 5-digit
number) for the manufacturer of the component
whose signals you want to store in the memory.
• The top IR segment blinks once after each button press.
• If the remote recognizes the manufacturer's code, the
IR segment blinks twice.
You have 10 seconds to press each digit. If it takes longer
than that, the remote "times out" and you must begin
again.
NOTE:
• Depending on the model and year of manufacture, this
function cannot be used for some models, even if the your
device is listed on the included list of preset codes.
• Some manufacturers use more than one type of remote
NUMBER
control code. Refer to the included list of preset codes to
change the number and check it out.
SETUP
2 The preset codes are as follows upon
shipment from the factory and after resetting:
• TV, VCR .........................................HITACHI
• CD, DVD........................................DENON
• SAT ................................................RCA
DVD-555
DVD-755
DVD-900
DVD-910
DVD-955
button for the DVD-1000
DVD-1200
DVD-1500
DVD-1710
DVD-1910
DVD-2200
DVD-2800
button for at least
DVD-2800
DVD-2900
End of this manual ), press the
DVD preset codes
41470 (default) 40490
DVD-2910
DVD-800
DVD-3800
DVD-1600
DVD-3910
DVD-2000
DVD-5900
DVD-2500
DVD-5910
DVD-3000
DVD-9000
DVD-3300
DVM-715
DVM-1800
DVM-1805
DVM-1815
DVM-2815
DVM-4800
II
53
Operating a component stored in the preset
memory
NUMBER
1
MODE SELECTOR
Press the
component you want to operate.
2
Operate the component.
For details, refer to the component's operating instructions.
Some models cannot be operated with this remote control
unit.
• For the DVD player remote control buttons, function names
may differ according to manufacturer. Compare with the
remote control operation of the various components.
Advanced Operation
button for the