Installing The Cam Stack Assembly And Cycle Lever Assembly - Kodak CAROUSEL NEW LOOK PROJECTOR Service Manual

HALF-CYCLE
LEVER
HALF-CYCLE
LEVER SPRING
CYCLE
LEVER
PLUNGER
SPRING
PLUNGER
CYCLE
SOLENOID
SCREW (2)
INDEX LEVER
and SPRING
(not shown)

Installing the CAM STACK ASSEMBLY and CYCLE LEVER ASSEMBLY

SM5440-1 – 18NOV97
[20] Remove the 2 SCREWS from the CYCLE
[21] Remove the CYCLE SOLENOID.
[22] Slide the PLUNGER and PLUNGER SPRING off
E-RING (2)
[23] Remove the HALF CYCLE SPRING between the
[24] Disconnect the INDEX LEVER SPRING from the
[25] Push the INDEX LEVER back.
[26] Remove the 2 E-RINGS:
Keep both the CYCLE LEVER ASSEMBLY and the
HALF CYCLE LEVER together and observe the
orientation of both LEVERS.
[27] Slide both the CYCLE LEVER and HALF CYCLE
A091_0009CCA
A091_0009CA
Keep both the CYCLE LEVER ASSEMBLY and the
HALF CYCLE LEVER together and observe the
orientation of both LEVERS.
[1] Do the replacement procedure for the CAM
Replacements and Installations
SOLENOID.
the CYCLE LEVER.
CYCLE LEVER ASSEMBLY and the HALF
CYCLE LEVER.
MECHANISM ASSEMBLY.
• 1 on the CYCLE LEVER ASSEMBLY
• 1 on the HALF CYCLE LEVER
Caution
LEVER off the SHAFT.
Caution
STACK ASSEMBLY and CYCLE LEVER
ASSEMBLY in reverse order.
17