Timer (Block Model 205) - Omron WS02-NSFC1-EV3 - 12-2007 Operation Manual

Timer (Block Model 205)

6-11 Timer (Block Model 205)

5: Alarm Setting
The alarm set values are displayed as a Bar graph. The set values for the H
and L alarms are displayed from right to left.
The set value for each alarm is displayed along with the X1 bar display on the
right side of the face plate, with the top value as 115% and the bottom value
as − 15%.
Alarm type Alarm setting tag ITEM
L (Low alarm) A2 (010)
H (High alarm) A1 (009)
• The alarm settings are displayed in red.
• The maximum value displayed is 11500 (115%) and the minimum value
displayed is − 1500 ( − 15%).
• The zero point is specified to be displayed.
6: MV Display, MV Change Button, and MV Index Position
The High/Low Alarm face plate does not provide an MV display, MV Change
Button, or MV index position.
7: Tuning Screen Button
The High/Low Alarm face plate does not provide a Tuning Screen Button.
The following diagram shows a High/Low Alarm face plate built using the Face
Plate Auto-Builder for NS in a 640 × 480 screen resolution.
The whole face is built using 458 × 142 dots.
The display and operation of each object in the face plate is the same as the
version for 800 × 600 screen resolution.
This section describes only the differences between the Timer Block and
Basic PID Block (Block Model 011). For details on the areas not covered here,
refer to 6-1 Basic PID (Block Model 011).
Section 6-11
79