Omron WS02-NSFC1-EV3 - 12-2007 Operation Manual page 139

Segment Program 3 (Block Model 158)
124
3: Backup Button
This button backs up data during operation. This is performed to back up
changed settings to the flash memory in the Loop Control Board. The backup
during operation function backs up the function blocks in the RAM in the Loop
Control Board to the flash memory in the Loop Control Board.
4: GRF and PRG Buttons
GRF Button: Opens the Step Data Graph Display Screen.
PRG Button: Opens the Step Data Setting Screen.
5: Bank Display Switching Buttons
Up to 5 banks can be displayed on each Bank Data Setting Screen. These
buttons display a different group of 5 banks.
01-05: Displays banks 1 to 5
11-15: Displays banks 11 to 15
21-25: Displays banks 21 to 25
31-35: Displays banks 31 to 35
41-45: Displays banks 41 to 45
51-55: Displays banks 51 to 55
61-65: Displays banks 61 to 65
71-75: Displays banks 71 to 75
81-85: Displays banks 81 to 85
91-95: Displays banks 91 to 95
6: Bank Data Display and Setting Buttons
These buttons are used to display and set bank data. The P, I, D, MH, and ML
parameters and the set values from 1 to 5 are displayed, and can be set, for
each bank. The set values from 1 to 5 are input as engineering units accord-
ing to scale data set in the destination function blocks.
Note Carefully consider the effects that changes will have on equipment before
writing any settings.
Section 6-19
06-10: Displays banks 6 to 10
16-20: Displays banks 16 to 20
26-30: Displays banks 26 to 30
36-40: Displays banks 36 to 40
46-50: Displays banks 46 to 50
56-60: Displays banks 56 to 60
66-70: Displays banks 66 to 70
76-80: Displays banks 76 to 80
86-90: Displays banks 86 to 90
96-100: Displays banks 96 to 100