Omron WS02-NSFC1-EV3 - 12-2007 Operation Manual page 8

About this Manual:
This manual describes the installation and operation of the WS02-NSFC1-EV2 Face Plate Auto-
Builder for NS. The Face Plate Auto-Builder for NS is a software package used to automatically build
project files for the CS1W-LC001 Loop Control Unit, the CS1W-LCB01 and CS1W-LCB05 Loop Con-
trol Boards, CS1D-CPU@@P Process-control CPU Units, and CJ1W-CPU@@P Loop Control CPU
Units used with NS-series Programmable Terminals. These files are based on the tag files created
using CX-Process Tool.
The project files that are created are configured using the Face Plate Screens for the Loop Control
Unit.
Please read this manual carefully and be sure you understand the information provided before
attempting to install and operate the Face Plate Auto-Builder for NS. Please read the following manuals
carefully and be sure you understand the information provided before setting up the Loop Control Unit/
Board and NS-series PT System
Manuals Related to the Loop Control Unit/Board
Product
WS02-NSFC1-E
Face Plate Auto-
Builder for NS
WS02-LCTC1-EV3
CX-Process Tool
CXONE-AL@@C-E
CX-One FA Integrated
Tool Package
WS02-LCTC1-E
CX-Process Monitor
WS02-LCMC1-E
CX-Process Monitor
Plus
CS1W-LC001
Loop Control Unit
CS1W-LCB01/05
@@
CS1D-CPU P
Loop Control Boards
CS1W-LC001
Loop Control Unit
CS1W-LCB01/05
@@
CS1D-CPU P
Loop Control Boards
Manual name
Face Plate Auto-Builder
for NS
Operation Manual
CX-Process Tool
Operation Manual
CX-One
Setup Manual
CX-Process Monitor
Operation Manual
CX-Process Monitor Plus
Operation Manual
Loop Control Unit
Operation Manual
Loop Control Board
Operation Manual
Loop Control Unit
Function Block Reference
Manual
Loop Control Board
Function Block Reference
Manual
Cat. No.
W418 (this manual) Installation and operation procedure for
Face Plate Auto-Builder for NS.
W372 Installation and operation procedures
for the CX-Process Tool.
W444 Provides an outline of the CX-One FA
Integrated Tool Package and the instal-
lation procedure. Refer to this manual
when installing software contained in
the CX-One FA Integrated Tool Pack-
age.
W373 Installation and operation procedures
for the CX-Process Monitor.
W428 Installation and operation procedures
for the CX-Process Monitor Plus.
W374 Installation and operation procedures
for the Loop Control Unit (except for
function blocks).
W406 Installation and operation procedures
for the Loop Control Boards (except for
function blocks).
W375 Detailed information on function blocks
for Loop Control Units.
W407 Detailed information on function blocks
for Loop Control Boards
Contents
ix