Omron SENSOR SUPPORT SOFTWARE S3 Operation Manual page 56

Display window for new sensor settings New settings of E3NT-R
8-5-1-1-1 Switching inversion
8-5-1-1-2 On-switching mode
56
Switching inversion of the output is set in the Switching inversion box.
Light-On
The output is active when the light beam is received via the reflector
on the receiver.
Dark-On (factory default)
The output is active when an object is interrupting the light beam
between sensor and reflector.
The on delay of the output is set in the On-switching mode box.
The on delay is activated or deactivated with the On delay checkbox.
In the Dark-On mode, the on delay is the time from detection of an
object in the switching zone to activation of the switching output.
The on delay can be set in several ways:
• By slider
The position of this slider can be altered by dragging with the mouse.
The resulting set delay is displayed next to the slider as a number.
This number can be increased or reduced with the slider's Increment and
Decrement buttons.
• With number input
The delay can also be entered directly as a number. The slider is adjusted
accordingly.
The On delay cannot be activated, if Off delay is set to minimum
pulse width or constant pulse width.
Section 8-5