Program Control Keys - Omron SENSOR SUPPORT SOFTWARE S3 Operation Manual

Program control keys

Section 6-1
6-1 Program control keys
The following program control keys are used in the SensorSupportSoftware:
Reset screen size
The active window is reseted to the full screen size.
Reduce window
The active window is displayed in a reduced size.
Expand window
The active window is displayed in an increased size.
Open file
Loads settings/diagram.
Save parameter
The current settings/diagrams in the active window or measurement
protocol data are saved.
Print
The current settings/diagrams in the active window or the settings of
the active window are printed.
Write to sensor
The current parameters are transferred to the sensor. This is only
possible if the Read & Write access to sensor mode is set.
Load from sensor
The current parameters are read from the sensor.
Decrease
Reduces the value by 1.
Increase
Increases the value by 1.
Start measurement
Starts the recording of the sensor value time chart.
Pause measurement
Pauses the recording of the sensor value time chart.
Erase / restart measurement
Erases the measurement or starts it again.
2D view
Changes to 2-dimensional view of the time chart.
22