Omron NSH5 Operation Manual page 53

Installing the Mounting Bracket
Note
Mounting the Visor
Note
32
2. Secure the mounting bracket to the PT with the two screws.
Tighten the screws to a force of 0.9 N.
3. Attach a screw or other support to the wall first and then hook the mounting
bracket on it to install NSH5.
Screw or other support
(Provided by the customer)
Diameter: 5 mm
Diameter: 10 mm
The emergency stop switch or the stop switch could be inadvertently turned
ON if the PT falls forward when used in a non-mounted condition. The Visor
prevents this type of error from occurring. Mount it as shown below, using
screws on the top and rear surfaces.
Tighten the screws to a force of 0.9 N.
Mounting bracket
Mounting bracket
Section 2-5