Memory Cards; Memory Card Applications - Omron NSH5 Operation Manual

Memory Cards

3-5 Memory Cards
3-5-1

Memory Card Applications

38
The following points apply to the function switch allocations.
• Only bit addresses can be set.
• Addresses can be set in either internal memory or host memory.
• System memory $SB cannot be allocated.
• No address is allocated for the default setting.
The NS Handy Terminal Tab can be selected only when the PT model is set
to the NSH5. It cannot be selected for any other PT model.
Memory Cards are used for storing and transferring screen data, log data,
and system programs. This section provides an overview of Memory Card
functions. Refer to the NS-Designer Operation Manual (Cat. No. V074-E1) for
details on Support Software transferring methods.
Memory Cards can be used at the PT itself. Log files can be saved to a Mem-
ory Card as CSV files. There are four kinds of log files, as shown in the follow-
ing table.
Alarm/event Stores alarm/event history data that has been registered by CX-
history Designer.
Data log Stores trend data.
Operation log Stores screen operation log data.
Error log Stores error log data for when macros are executed.
Log data is normally saved in internal memory that is backed up in the PT, but
can also be saved in CSV file format. When log data is saved as a CSV file, it
is stored on the Memory Card. The CSV files containing log data are saved in
the log folder created in the Memory Card.
The following data can be transferred using a Memory Card.
• System programs (programs required for operating the PT, such as for
communications and fonts)
Section 3-5
Allocate addresses in internal
memory or host memory to
function switches F3 to F5 and
F8 to F10.