Omron NQ HMI Getting Started Manual page 34

Preparing for programming
4-1-5-2 USB cable
20
In order to use a USB cable the USB driver needs to be installed on the PC
operating system. Perform the following steps to install the USB driver.
1 Connect the USB cable to the PC and NQ-Series.
2 When the PC detects the NQ-Series the following message is displayed:
Found New Hardware: HMI USB Device.
On the dialog select Found New Hardware Wizard, No, not this time
and click Next (It depends on the environment whether the message is
displayed or not.).
3 Select Install from a list of specific location and click Next.
4 Ensure that Include this location in the search is checked and browse to
the following location:
C:\Program Files\OMRON\NQ-Designer\USBDrivers\
5 Click Next to install the USB driver.
6 If the Hardware Installation dialog is displayed, click Continue Anyway.
7 Click Finish to complete the installation.
A correct installed driver will show a message on the NQ-Series' screen: USB
device status: Connected (This message is only shown when no firmware is
downloaded in the NQ).
Section 4-1