Omron NQ HMI Getting Started Manual page 124

11 Connect the cable to the NQ-Series and PLC. Refer to A-4-8 NQ to Schneider Twido. Connect MiniDIN port
of the cable to the PLC port. Connect the male port of the cable to the defined COM1 port of the NQ-Series.
12 Enter 4568 in the NQ-Series' screen. If the connection has been correctly established the same value is
shown in Twido software.
Note
The following messages are displayed on the NQ-Series' screen if problems occur:
• !!! no connection
• ??? connection established, address unknown
110