Note
•
H5-07 = 0 (RS-485 connection): Create the applicable cable. Refer to (V1000 RS-485 connection) A-2-5.
•
NQ-Series establishes a connection to the inverter by exchanging a default address HR400001. If this
address is not available in the used inverter, the connection will not be established. To establish the
connection proceed as follows.
1 Click in the Nodes folder and right-click the Node1 inverter.
2 Click Edit.
3 Click PLC Specific Setting.
4
5 Change Default communication register address to an available address in the inverter.
6 Click OK.
7 Download the application to the NQ-Series.
•
The following messages are displayed on the NQ-Series' screen if problems occur:
•
!!! no connection
•
??? connection established, address unknown
80