Installation; Standard Connections; Terminal Block Specifications - Omron JX - DATASHEET 1 System Configuration Manual

Installation

Standard connections

3-phase 200 V AC
1-phase 200 V AC
3-phase 400 V AC
Frequency
meter
Frequency
setting unit
1 to 2 kΩ
Power supply input
4 to 20 mA DC

Terminal Block Specifications

Terminal
Main circuit power supply input
R/L1, S/L2, T/N/L3
Inverter output
U/T1, V/T2, W/T3
External DC reactor terminal
PD/+1, P/+
Regenerative braking unit connection
P/+, N/-
terminal
Grounding
6
R (L1)
S (L2)
T/N (L3)
For Source logic
P24
5
4
3
2
1
PCS
L
AM
10 V DC
H
O
OI
L
Name
Inverter
4.7 kΩ
10 kΩ
250 Ω
Used to connect line power to the drive.
Drives with single-phase 200 V input power use only terminals R/L1 and N (T/L3), terminal
S/L2 is not available for these units
Used to connect the motor
Normally connected by the short-circuit bar. Remove the short-circuit bar between +1 and
P/+2 when a DC reactor is connected.
Connect optional regenerative braking units (If a braking torque is required)
For grounding (grounding should conform to the local grounding code.)
U/T1
V/T2
Motor
W/T3
Note:
To connect the DC reactor,
remove the short-circuit bar.
PD/+1
DC reactor
P/+
N/-
AL1
AL2
Relay output
AL0
Common
11
RY
CM2
Function (signal level)
Frequency inverters
24 V DC