Omron G3ZA - MANUAL 2 User Manual page 26

Installation
Mounting the G3ZA
Removing the G3ZA
Mounting End Plates
Note
Mount the G3ZA as shown in the diagram. First, pull down the DIN Track
mounting hook (1) and hook the top of the G3ZA on the DIN Track (2). Then
press the G3ZA onto the DIN Track far enough so that it can be locked in
place (3) and push the DIN Track mounting hook up to lock the G3ZA in place
(4).
(2)
(3)
(1)
Use a flat-blade screwdriver to pull down the DIN Track mounting hook (1) and
then pull out on the bottom of the G3ZA (2).
(1)
Be sure to mount an End Plate on each side of the G3ZA so that it does not
slide on the DIN Track.
To mount an End Plate, hook the bottom of the End Plate on the bottom of the
DIN Track (1), place the top of the End Plate on the DIN Track (2), and then
pull down on the End Plate. Tighten the screw on the End Plate to secure it.
READY
SD/RD
SW 1
OCC
SW 2
ERROR
Always mount one End Plate on each side of the G3ZA.
(4)
(2)
(2)
(1)
Section 2-1
9