Parameter Specifications - Omron CX-PROGRAMMER V8.1 Operation Manual

Instance Specifications
2-3-2

Parameter Specifications

Input Contents
variable
data type
BOOL Bit data
Program 1 (automatic operation)
Product A counter
CTD
CD Q
LD
PV CV
Product B counter
CTD
CD Q
LD
PV CV
Program 1
Instance A
FB
Instance B
FB
Program 2
Instance A
FB
The data that can be set by the user in the input parameters and output
parameters is as follows:
Item
Input parameters
Output parameters
Input-output parame-
ters
Note (1) The following table shows the methods for inputting values in parameters.
Size
1 bit
Program 2 (manual operation)
D100
Reading the same product's counter
value at different locations
Reading different products' counter values
(Algorithm calculating counter value is the same.)
D200
Instance A
I/O variables,
Internal
variables
Body
Instance B
I/O variables,
Internal
variables
Body
Use the same internal variables
Use different internal variables
Values (See note 1.), addresses, and program symbols (glo-
bal symbols and local symbols) (See note 2.)
Note The data that is passed to the input variable from the
parameter is the actual value of the size of the input
variable data. (An address itself will not be passed even
if an address is set in the parameter.)
Note Input parameters must be set. If even one input param-
eter has not been set, a fatal error will occur and the
input parameters will not be transferred to the actual
PLC.
Addresses, program symbols (global symbols, local symbols)
(See note 2.)
Addresses, program symbols (global symbols, local symbols)
Parameter value input
method
P_Off, P_On
Section 2-3
Product B counter
CTD
CD Q
LD
D150
PV CV
FB definition
Variable
definitions
Body
Applicable data
Setting range
0 (FALSE), 1 (TRUE)
47