Parameter Specifications - Omron CX-PROGRAMMER 5.0-FUNCTION BLOCK OPERATION Operation Manual

Instance Specifications
2-2-2

Parameter Specifications

Note
Input Contents
variable
data type
BOOL Bit data
INT Integer
DINT Double integer
LINT Long (8-byte) integer
34
Program 1 (automatic operation)
Product A counter
CTD
CD Q
LD
D100
PV CV
Product B counter
CTD
CD Q
LD
D200
PV CV
Program 1
Instance A
FB
Instance B
FB
Program 2
Instance A
FB
The data that can be set by the user in the input parameters and output
parameters is as follows:
Item
Input parameters Values (See note 1.), addresses, and program symbols (glo-
bal symbols and local symbols) (See note 2.)
Note The data that is passed to the input variable from the
Note Input parameters must be set. If even one input param-
Output parameters Addresses, program symbols (global symbols, local symbols)
(See note 2.)
(1) The following table shows the methods for inputting values in parameters.
Size Parameter value input
1 bit P_Off, P_On
16 bits Positive value: & or + followed
by integer
32 bits
Negative value:
64 bits
integer
Program 2 (manual operation)
Product B counter
CTD
CD
LD
PV
Reading the same product's counter
value at different locations
Reading different products' counter values
(Algorithm calculating counter value is the same.)
Instance A
I/O variables,
Internal
variables
FB definition
Body
Variable
definitions
Body
Instance B
I/O variables,
Internal
variables
Body
Use the same internal variables
Use different internal variables
Applicable data
parameter is the actual value of the size of the input
variable data. (An address itself will not be passed even
if an address is set in the parameter.)
eter has not been set, a fatal error will occur and the
input parameters will not be transferred to the actual
PLC.
method
0 (FALSE), 1 (TRUE)
−32,768 to 32,767
−2,147,483,648 to 2,147,483,647
−
−9,223,372,036,854,775,808 to
followed by
9,223,372,036,854,775,807
Section 2-2
Q
D150
CV
Setting range