Entry Of Advanced Instructions 3 - Entry By Fun No - Omron CX-PROGRAMMER - INTRODUCTION GUIDE Introduction Manual

Installation
Installation
to Startup
to Startup
I
021
The instruction
The instruction
corresponding to the
corresponding to the
entered Fun No. is
entered Fun No. is
displayed.
displayed.
Enter
ENT
#0 D0
ENT
R
Note:
Note:
The Fun No. of MOV
The Fun No. of MOV
depends on PLC types.
depends on PLC types.
CS-series -> 021
CS-series -> 021
CJ-series -> 021
CJ-series -> 021
CV-series -> 030
CV-series -> 030
C-series -> 21
C-series -> 21
Opening a
Opening a
new project
new project

5-16. Entry of Advanced Instructions 3 - Entry by Fun No.

Device type
Device type
settings
settings
Show the [New Instruction] dialog.
Show the [New Instruction] dialog.
Refer to the section 5-4 to enter a rung comment.
Creating a
Creating a
program
program