Connecting the Programming Console
Contrast Control
Buzzer
7-2-2
Changing the CQM1H's Mode with the Mode Switch
150
The display contrast can be adjusted with the control on the right side of the
Programming Console.
The C200H-PRO27-E's buzzer volume can be adjusted with the lever on the
right side of the Programming Console. The CQM1H-PRO01-E or CQM1-
PRO01-E's buzzer volume cannot be adjusted.
Note The buzzer can be turned ON and OFF with a key operation. See 7-3-4
Buzzer Operation for details.
Once the Programming Console has been connected, its mode switch can be
used to change the CQM1H's operating mode. The mode display (<PRO-
GRAM>, <MONITOR>, or <RUN>) will appear on the Programming Console
screen.
• No key operations can be performed while the mode display is displayed
on the Programming Console screen. Press CLR to clear the display so
that key operations can be performed.
• If the SHIFT Key is pressed while the mode switch is turned, the original
display will remain on the Programming Console's screen and the mode
display won't appear.
Contrast control
C200H-PRO27-E
Section 7-2
Low volume
High volume