Omron CJ - REFERENCE MANUAL 07-2009 Reference Manual page 254

FINS Commands
Precautions
232
CompoWay/F Command Code
This is the CompoWay/F command code. For details, refer to the command
manual for the CompoWay/F Slave.
CompoWay/F Response Code
The CompoWay/F response code indicates the results of the service
requested by the command code. For details, refer to the command manual
for the CompoWay/F Slave.
CompoWay/F Text
This is the data that follows the response code.
• FINS Header (Destination Address)
The following settings are required.
• Destination Network Address (DNA):
• When a routing table is created to treat the serial communications path
as a network, this is the network address associated with the Serial
Communications Unit or Board's serial port by the routing table
• When a routing table is not created to treat the serial communications
path as a network, this is the actual network address used to specify
the destination PLC.
• Destination Node Address (DA1):
• When a routing table is created to treat the serial communications path
as a network, set 00 hex for communications within the local PLC or
the "Host Link unit number + 1" for serial → serial → serial conversion.
• When a routing table is not created to treat the serial communications
path as a network, this is the actual node address used to specify the
destination PLC (the "Host Link unit number + 1" for serial → serial →
serial conversion).
• Destination Unit Address (DA2):
This is the serial port's unit address.
Settings for a Serial Communications Board or Unit:
• Unit addresses for serial port 1:
Unit number 0 1 2
Hexadecimal 80 84 88
Decimal 128 132 136 140 144 148 152 156 160 164 168 172 176 180 184 188 228
• Unit addresses for serial port 2:
Unit number 0 1 2
Hexadecimal 81 85 89
Decimal 129 133 137 141 145 149 153 157 161 165 169 173 177 181 185 189 229
• Sending CompoWay/F Commands with the CMND Instruction
• Set FINS command code 2803 hex (CONVERT TO COMPOWAY/F) in
S.
• Set the following parameters starting at S+1 in ASCII with the leftmost
byte first: CompoWay/F node number (2-byte ASCII), subaddress (2-
byte ASCII), SID (2-byte ASCII), CompoWay/F command MRC (2-byte
ASCII), CompoWay/F command SRC (2-byte ASCII), and text (ASCII,
2 × n bytes)
3 4 5 6 7 8
8C 90 94 98 9C A0
3 4 5 6 7 8
8D 91 95 99 9D A1
Section 5-3
9 A B C D E
A4 A8 AC B0 B4 B8
9 A B C D E
A5 A9 AD B1 B5 B9
F Board
BC E4
F Board
BD E5