Omron A16 Datasheet page 25

■ Panel Cutouts
Solder Terminals
Rectangular A16@-J/M16@-@J
(Top View)
16 +0.2 dia.
24 min.
0
19 min.
Note: 1. Make sure the thickness of the mounting panel is between 0.5 and 3.2 mm. If, however, a Switch Guard or Dust Cover is used, the thick-
ness of the mounting panel must be between 0.5 and 2 mm.
2. If the panel is to be finished with coating, etc., make sure that the panel meets the specified dimensions after coating.
PCB Terminals
Rectangular A16@-J/M16@-J
(Top View)
16 +0.2 dia.
24 min.
0
24 min.
Note: 1. Ensure that the variation in the distance between the centers of neighboring mounting holes is less than 0.1 mm.
2. Make sure the thickness of the mounting panel is between 0.5 and 3.2 mm. If, however, a Switch Guard or Dust Cover is used, the thick-
ness of the mounting panel must be between 0.5 and 2 mm.
3. If the panel is to be finished with coating, etc., make sure that the panel meets the specified dimensions after coating.
Square A16@-A/M16@-A
Round A16@-T/M16@-T
(Top View)
+0.2
16 dia.
0
19 min.
19 min.
Square A16@-A/M16@-A, A165@-BA, M165-BA
Round A16@-T/M16@-T
(Top View)
+0.2
16 dia.
0
24 min.
24 min.
Pushbutton Switch
A16
G-29