Omron 2D CODE READER User Manual page 8

■ Installation and Handling of Components
• Use the cables specified in this manual.
p.20
• Keep the power supply cable as short as possible (10 m maximum).
• The power lines and discrete I/O lines of the communication/power cable should not
be short-circuited with each other.
• Power output lines of the monitor cable should not be short-circuited with each other.
• Do not supply power from the monitor's power cable, since it is provided for output
only.
• Do not attempt to dismantle, repair, or modify the product. Failure to observe this may
result in breakdown or fire.
■ Connecting and Removing Cables
• Do not connect or disconnect the cables while power is supplied.
• Do not connect a cable to the 2D Code Reader if the other end of the cable is
connected to a personal computer or a Programmable Controller.
• To prevent damage from static electricity, use a wrist strap or another device for
preventing electrostatic charges when touching terminals or signal lines inside
connectors.
■ Turning OFF the Power Supply
• Do not turn OFF the power supply while a message is being displayed indicating that
processing is being performed. Data in memory will be destroyed, and the product
may not operate correctly the next time it is started.
• Do not turn OFF the power while the setting data is being saved. Data in memory will
be corrupted, and the product may not operate correctly the next time it is started.
Introduction
V400-F050/250/350
User's Manual
7