Sennheiser SYSTEM 2015 Instructions For Use Manual page 43

Selecting the frequencies to be stored in the channel bank "U"
TUNE Via the "TUNE" menu, you can select the frequencies to be stored in the
channel bank "U" (user bank). When selecting the "TUNE" menu, the trans-
mitter or receiver automatically switches to the channel bank "U".
To release individual channels, select the desired channel by using the
/ rocker button (UP/DOWN). (By briefly pressing the button, the
display jumps either forwards or backwards to the next channel; by hol-
ding down the button, the display cycles continuously.)
Note:
You can display the frequency stored in the selected channel. To do so,
press the SET button and the
Briefly press the SET button. The selected channel can now be accessed
by the user. "ACCESS" briefly appears on the display and the display
then displays the next channel that can be released.
Have you released all required channels as described above? Store your
settings by pressing the
play.
Note:
Always assign the same frequency to the same channel on both trans-
mitter and receiver.
Use the / rocker button (UP/DOWN) to select the channel for which
you want to set the frequency.
Press the SET button to confirm your selection. The currently set fre-
quency is displayed.
Use the / rocker button (UP/DOWN) to select the desired transmis-
sion or receiving frequency. The frequencies are tunable in 25-kHz
steps within a switching bandwidth of 36 MHz max. For intermodula-
tion-free frequencies, please refer to the enclosed frequency table.
button (UP) simultaneously.
SET button until "STORED" appears on the dis-
95