Recommendations And Tips - Sennheiser SYSTEM 2015 Instructions For Use Manual

Problem
No access to a certain
channel
If problems occur that are not listed in the above table or if the problems cannot be solved with the pro-
posed solutions, please contact your technical expert for assistance.

Recommendations and tips

... for system planning
Transmitter and receiver of a transmission link must be set to the same frequency.
A transmitter can be received by several receivers on the same frequency.
However, a receiver cannot receive several transmitters on the same frequency. Incorrect settings are
indicated by crackling and chirping in the receiver.
... for the MKE 2015-0 plug-on microphone (optional accessory)
Adjust the length of the neck strap so that the distance between the microphone and your mouth is
9.8 inches at the most.
The plug-on microphone allows you to transmit group discussions. For this purpose, place the trans-
mitter on the table on a soft and springy pad.
... for the ME 2015-H headset microphone (optional accessory)
Always use the microphone with a popshield and position the microphone at the corner of the mouth.
You can vary the bass reproduction by increasing/decreasing the talking distance.
Make sure that the sound inlet is directed towards the mouth. The sound inlet is marked with a little
dot.
... for the SK 2015 transmitter
Make sure that the antenna and the microphone cable do not cross.
For best results, make sure that the transmitter sensitivity is correctly adjusted.
Possible cause
The channel has not been released. Set transmitter and receiver to a
Possible solution
different channel.
The technical expert must release the
channel.
85